Zebra LP2844 Printer How-To Guides
- How do I install Zebra LP2844 printer drivers on my computer?
- How do I load media on my Zebra LP2844 thermal printer?
- How do I calibrate my Zebra LP2844 thermal printer?
- How do I perform a self test on my Zebra LP2844 thermal printer?
- What does it mean when my Zebra LP2844 thermal printer has a blinking red light?
Zebra LP450 Printer How-To Guides
- How do I install Zebra ZP450 printer drivers on my computer?
- How do I load media on my Zebra ZP450 thermal printer?
- How do I calibrate my ZebraZP450 thermal printer?
- How do I perform a self test on my Zebra ZP450 thermal printer?
- What does it mean when my Zebra ZP450 thermal printer has a blinking red light?
Tools
Drivers / Printer Installation kit
Manual
Calibrate Zebra LP2844 thermal printer
- Make sure you have configured your driver or application for the media type you are using. Gap/Web or Black Bar (Mark). Send a test print to the printer before preceding so it is properly configured. Note: You can only send data when the button is green so cycle power if the printer button is red.
- Turn off printer and have media loaded
- Hold feed button down, and turn printer back on
- When the red light starts flashing, release the feed button.
- Printer light will turn green and advance a few blanks.
- After printer stops advancing and prints the internal information, press the feed button one time.
- You will get another label with the “Out of Dump” message on it.
The printer should feed one label each time you press the Feed Button. If one label is issued each time you press the Feed Button the printer has been properly calibrated.
